HOME ] Modern Technology for Today's Industries, 800-234-7326 or email

                                              

USB and Wireless CNC Minifile™  Part Program Loader
Overview          
 
bulletUSB Flash Drive, 802.11 Wireless
bulletUpgrade your existing CNC Minifile
bullet10/100 BaseT Ethernet interface
bulletCan be a member of a domain
bulletInterfaces to virtually any NC/CNC machine
bulletUpload, Download and Drip Feed
bulletPull or push part program from your DNC network
bulletBuilt-in serial protocols for machine compatibility
bulletRS-232C serial and behind the tape reader (BTR)

 

 

USB Minifile can operate stand-alone or join your LAN

 

USB Minifile is a part program loader to load memory on or drip feed to CNC machine tools   The device operates standalone through its USB flash drive or floppy disk and it can join a network via 10/100 base-T Ethernet or Wireless 802.11b/g. 

 

bulletCompatible with virtually any NC or CNC machine tool control.  See Control List
bulletPull programs directly from your File Server using Ethernet or Wireless 802.11b/g
bulletEliminates punch tape equipment on older machine tools via Behind the Tape Reader (BTR)
bulletOperates in parallel (BTR) and serial (RS-232) communications modes
bulletLocal keypad operation or remote operation using a PC on the LAN

RUGGEDIZED FOR THE MACHINE SHOP

Designed and engineered specifically for use in machine shop environments, the portable USB CNC Minifile can easily be carried to NC programming station and machine tools on the shop floor. A single portable device has the built-in protocols necessary to communicate with virtually any machine tool control.

MULTITASKING

The USB Minifile runs under a multitasking operating system. This allows the user to run a job on a machine tool and at the same time the programmer can quickly transfer NC programs even while another program is being loaded to the control. No waiting and idle time.

SUPPORTS VIRTUALLY ANY MACHINE TOOL

Thousands of punched tape reader/control combinations have been successfully interfaced with using both the Behind the Tape Reader or BTR (parallel) and serial communications supported by USB CNC Minifile. With over 100,000 units sold world-wide in the machine tool market, USB CNC Minifile's proven field performance is unsurpassed.

LOW COST MEMORY EXPANSION

Machine controls capable of either running directly off punched tape or through the RS-232C port in DNC mode can operate directly from USB Minifile USB flash drive or off a server on a LAN.  A single part program can be virtually unlimited in size without having to segment the program.

 

 

GRECO SYSTEMS ® is a registered Trademark with the United States Patent and Trademark Office


Copyright © 2004 - 2010              This page was updated 01/21/2010